CODEWRITER 5106 DRIVER

Then perform the test printing again. Rotate the head pressure screw clockwise fully. Refer to the parameter tree, page 8 for 1. Push back the thermal head lever in order to release the thermal head block from the platen roller. Over-tightening hexagon bolt may cause the screw thread to break. Place the label roll on the label roll support and push it into the label roll compartment until the roll touches the frame.

Uploader:	Voodoora
Date Added:	12 June 2011
File Size:	55.10 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	1608
Price:	Free* [*Free Regsitration Required]

Ribbon Adjustment To understand ribbon adjustment better, refer to the following explanation.

Thermal Head Positioning Thermal Head Positioning If you have replaced the thermal codewfiter, positioning should be checked. Repeat Steps 10 through 13 as required until the right part of the contrast of Result 1 is better than Result 2 or 3. Depress [1] [4] [1] or [1, 4, 1] means: Over-tightening hexagon bolt may cause the screw thread to break.

Copyright Notice This guide is copyrighted. Too much lifting up of the thermal head will result in too light weak of a contrast in printing.

Amt datasouth printer user's guide amtaccel pages.

This guide may not, in whole or part, be reproduced, translated, stored in a retrieval system or transmitted in any forms or by any means, electronic, mechanical, photographic, or otherwise, without the prior written consent of AMT Datasouth Corp.

Then fix the applicator again.

CodeWriter Thermal Printer

See Figure 8 If not, adjust the alignment following Steps 5 through 7. Ribbon running condition within Part C does not normally cause problems. Check to see if the bottom edge of the ribbon applicator aligns to coxewriter bottom edge of the thermal head. Page of 36 Go. Make sure to power off the printer prior to the replacement of the thermal head.

Place the label roll on the label roll support and push it into the label roll compartment until the roll touches the frame.

AMT Datasouth CodeWriter 5106 Technical Reference

The phillips screwdriver is used for loosening and tightening screws while the slotted screwdriver is used to adjust the position of moveable parts. Enter text from picture: Open right side cover to access label roll compartment.

The following keys are provided for the parameter setting operations. Thermal Head Positioning Page 23 - Figure Page 20 - Figure 7. This gives the right side of the ribbon more tension by changing position of the ribbon applicator. If not, it can result in media slippage or incorrect codewirter problems.

Incorrect loading of ink ribbon or label roll may result in wrinkling of ribbon, feeding 516 of codewritee or printing fault. Adjusting the head pressure thumb screw will have a direct effect on the contrast, ribbon feeding, and form feeding.

CodeWriter Options and Accessories | AMT Datasouth

External Connector And Pin Assignments This guide is copyrighted. Head Positioning Page 24 - Figure Voltage Check And Adjustment Thermal Head Positioning If you have replaced the thermal head, positioning should be checked.

Refer to the parameter tree, page 8 for 1.

Verify the ribbon running condition as well. Assemble and setup the printer according to the customer application. Make sure of the following prior to the adjustment: Rotate the head pressure screw clockwise completely.